Ascotel® IntelliGate® 150/300 as of I7.9
Installation 81
syd-0210/1.7 – I7.9 – 12.2009
4. 5. 4 LAN switch module
LAN switch modules belong to the category of system modules and are fitted to
the two neighbouring slots WA0…WA4 (see Fig. 8). The WA1...WA4 slots are also
used for the Wiring Adapters. If a LAN switch module occupies slots WA1...WA4, no
interface cards can be fitted to the corresponding slots IC1...IC4. The AD2 terminal
cards are the exception
1)
(see "LAN switch module", page 37).
Tip
Use slots WA0 and WA1 for a LAN switch module. As a result equipping
slots WA2...WA4 is not limited to AD2 terminal cards.
1. Disconnect the system from the power supply.
Warning
Be sure to observe the "Safety regulations", page 61.
2. Remove the housing cover.
3. Place the module into two neighbouring slots WA0...WA4 and press it down
evenly as far as the stop.
4. Fit the housing cover.
5. Reconnect the system to the power supply.
1)
Not allowed in Australia
To Next Page
Loading...
