Aastra Ascotel IntelliGate 300 - Connection Via Main Distribution Board

Ascotel® IntelliGate® 150/300 as of I7.9
84 Installation
syd-0210/1.7 – I7.9 – 12.2009
4. 6. 2. 1 Connection via main distribution board
Fig. 30 Connection via main distribution board
The interface sockets on the front panel are connected with the (main) distribution
frame or the patch panels using either standard commercial or prefabricated con-
necting cables.
Prefabricated connecting cable
The cable is 6 m long and, at one extremity, has 12 RJ45 connectors for the inter-
faces on the front panel. Two of them have 4 cores; the others, 2 cores. This means
the cable is suitable for connecting the following interfaces:
• 2 network interfaces (T, S external) or 2 terminal interfaces (S), relay contacts/
control inputs of an ODAB options card or a combination thereof.
• 8 network interfaces (a/b) or 10 terminal interfaces (AD2, a/b) or a combination
thereof.
Notes:
– This cable cannot be used to connect Ethernet interfaces (see also
Tab. 54 "Connection of Ethernet interfaces", page 120).
– It is not possible to connect an ODAB door intercom interface with
only one cable (see also "Connection of a door intercom (TFE)",
page 113).
Tip
Use commercial connecting cables to connect the T interfaces.
.4
.4
Ascotel
IntelliGate
-AIN
DISTRIBUTION
BOARD