Aastra Ascotel IntelliGate 300 - DSP Module

Ascotel® IntelliGate® 150/300 as of I7.9
80 Installation
syd-0210/1.7 – I7.9 – 12.2009
Fig. 28 Jumper position on card ESST-2
Note
Any incorrectly fitted or missing wiring adapters are signalled by a red
flashing LED on the display after start-up (see "Wiring Adapter Malfunc-
tion Mode", page 187).
4. 5. 3 DSP module
DSP modules belong to the category of system modules and are fitted to the SM1
slot (see Fig. 8). DSP modules are stackable.
1. Disconnect the system from the power supply.
Warning
Be sure to observe the "Safety regulations", page 61.
2. Remove the housing cover.
3. Remove the fastening screw from module slot SM1.
4. Instead of the fastening screw, screw in the spacer sleeve enclosed with the
module.
5. Place the module on slot SM1 of the basic system (or onto a module already fit-
ted in that slot) and press down evenly on both connectors as far as the stop.
6. Secure the module with the fastening screw.
7. Fit the housing cover.
8. Reconnect the system to the power supply.
T
S
NC
NC
S/
T
T
S
NC
NC
S/
T
*UMPERIN
POSITION4
*UMPERIN
POSITION3
#ARD%334 #ARD%334
2)'(4 72/.'