Ascotel® IntelliGate® 150/300 as of I7.9
Operation and Maintenance 171
syd-0210/1.7 – I7.9 – 12.2009
6. Fit the housing cover.
7. Reconnect the system to the power supply.
6. 3. 3. 2 New card with fewer ports
A card is replaced by a similar card with fewer ports.
Procedure:
Change the card and put the PBX into operation again. Similar procedure as de-
scribed in "Replacing a defective interface card", page 170.
The following data is deleted:
• The system and terminal configuration data of the terminals on the terminalin-
terfaces that are no longer present in the new configuration.
• The system configuration data of the network interfaces that are no longer
present in the new configuration.
Tab. 78 Example: Reducing terminal interfaces
Note:
If the terminal configuration data of system terminals is deleted following
the reconfiguration of a card, a warning message will appear beforehand
to give you the possibility of cancelling the process. However, this is pos-
sible only if the configuration data of the original card was not already
deleted beforehand.
6. 3. 3. 3 New card with more ports
A card is replaced by a similar card with more ports.
Procedure:
1. Change the card and put the PBX into operation again. Similar procedure as de-
scribed in "Replacing a defective interface card", page 170.
2. Select ”Confirm system configuration” in the AIMS Configuration Manager.
3. Configure new ports.
TIC-4TS → TIC-2TS The configuration data of terminal interfaces 3 and 4 are deleted.
EADP4 → TIC-2TS The configuration data of all 4 terminal interfaces is deleted.
To Next Page
Loading...
