Aastra Clearspan 6757i - Phone Features; General Requirements; Headset;Handset Connection; Handset

___________________________________________________________________________________________
CS 6757i IP PHONE USER GUIDE V3.2.2 AASTRA - 2788-003
CLEARSPAN® IS A REGISTERED TRADEMARK OF AASTRA TECHNOLOGIES LTD. PAGE 16 OF 116
2.2.1 Phone Features
 11-line graphical LCD screen (144 x 128 pixels) with white backlight.
 12 multi-functional softkeys.
 6 Top Keys: Static programmable softkeys – (up to 10 programmable functions).
 6 Bottom Keys: State-based programmable softkeys - (up to 20 programmable functions).
 4 line appearance keys with corresponding status lamps.
 Supports up to 9 lines.
 Full-duplex speaker for hands-free calls.
 Headset support (modular connector).
 Built-in two-port, 10/100 Ethernet switch allowing you to share a connection with your
computer.
2.2.2 General Requirements
The 6757i requires the following environment:
 A SIP-based IP PBX system or network installed and running with a SIP account created for
the 6757i.
 Access to a Trivial File Transfer Protocol (TFTP) server.
 Ethernet/Fast Ethernet LAN (10/100mb).
 Category 5/5e straight through cabling.
 Power Options:
 Power over Ethernet (PoE) 802.3af
 Inline power injector – An optional accessory necessary only if your network provides no
inline power.
 AC power adapter, included with the phone.
2.3 Headset/Handset Connection
2.3.1 Handset
Turn the phone over and locate the handset jack marked . Insert one end of handset cord
into the jack until it clicks into place. Then route the handset cord through the groove as shown in
the illustration below. Attach the handset to the other end of the handset cord.