Aastra OpenCom 510 - Page 209

Aastra OpenCom 510

212 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Index

207

Notes

Table of Contents

Default Chapter3
- Table of Contents3
Features11
Factory Settings16
- Telephony Functions16
- Authorisations16
- Internet Functions19
Preliminary Information21
- Construction of the Opencom 51021
- Scope of Delivery21
- Declarations of Conformity22
Installation23
- Safety Precautions23
- General Instructions23
- Notes on the Mains Supply24
- Notes on EMC and Earthing24
- Notes on Installing the Opencom 51025
- Notes on Installing Terminals26
- Installation, Ambient Conditions26
- Installation in a 19" Rack27
- Installing Modules28
- Slots29
- Notes on Disconnecting the Mains Supply30
- Installing the Central Control Module31
- Installing Interface Cards33
- Installing a Power Supply Unit35
- Backplane36
- Uninterruptible Power Supply39
- Power Failure39
Interfaces and Connectible Terminals41
- Overview41
- S Ports42
- Termination43
- External ISDN Ports (S External)45
- Internal S46
- Ports46
- U Pn Ports46
- Terminals Connected to U Pn Ports46
- Internal S 0 Ports46
- Technical Information47
- DECT Base Station Connection Variants48
- A/B Ports50
- Terminals Connected to A/B Ports50
- Technical Information52
- LAN Port53
- DSL Port53
- Service PC54
- COM Port54
Accessories and Adapters56
- U Pn Adapter56
- A/B Adapter56
- Audio Adapter57
- Approved Devices / Approved Accessories58
- Device Combinations59
Modules63
- Module Naming Conventions64
- Overview of Available Modules65
- Mps+1-Ac67
- MC+1-370
- Mt+S2M1-174
- MX+S01-878
- Ms+Upn1-881
- Ms+Upn2-883
- Ms+A1-885
- Ms+A1-487
Configuration89
- Brief Guide to Initial Configuration90
- Configuring the Opencom 51092
- Preparing the Configuration92
- Starting the Web Console92
- Loading the Online Help94
- Finishing the Configuration94
- Preconfiguration95
- Offline Configurator95
- Remote Configuration95
- Codes for IP Configuration97
- Saving and Loading the Configuration98
- Receiving System Messages as E-Mail98
- Loading SW Updates99
- Resetting the System Data99
- Generating Your Own Moh Files100
Configuration Examples101
- Opencom 510 in Computer Networks101
- Introduction to TCP/IP102
- Opencom 510 in a Serverless LAN103
- DNS Name Resolution104
- Internet Access104
- RAS Access105
- Opencom 510 in a LAN with an IP-Enabled Server106
- DNS Name Resolution106
- Internet Access107
- RAS Access108
- Branch Link109
- Useful Information on Internet Access110
- Costs110
- Using the Web110
- E-Mail111
- Nat111
Voice over IP (Voip)113
- Fundamentals114
- Propagation Delay and Bandwidth114
- Latency and Packet Length115
- Voice Quality116
- Optimisation118
- Call Set-Up118
- Useful Services119
- Media Gateway (MGW)119
- Mg+Eth1-1120
- SIP Telephony122
- Voip System Telephones124
- Device Properties124
- Voip System Telephone Configuration125
- LAN DHCP Server126
- Start Procedure127
- Openphone IPC129
- Installation130
- Configuration130
Dectnetip132
- Properties132
- DECT Base Stations132
- Features133
- Configuration133
- Dual Operation134
- Synchronisation135
PBX Cascading136
- Variants of PBX Cascading136
- Functionality of PBX Cascading136
- Putting a Cascaded PBX into Operation137
- Notes139
- Licensing Information140
PBX Networking142
- Connections143
- Protocol: Q.SIG or DSS1143
- Master/Slave144
- L1 Clock144
- Types of Point-To-Point Connections145
- Direct Connection145
- Connection Via an Active Transmission System146
- Connection Via the Public Network146
- Connection Via Q.SIG.IP147
- Configuration148
- Trunk Groups148
- Routes149
- Numbering149
- Technical Details151
Team Functions152
- Introduction152
- Explanation of Keys152
- Team Configuration154
- Examples of Use154
- Executive/Secretary Team154
- Three-Member Team155
- Unified Team156
- Toggle Team158
Call Queue160
- Introduction160
- Activation of Queues161
- Call Forwarding161
- Pickup162
- Hunt Groups162
- Examples of Use162
- Enquiry Station for an Operator with Two System Telephones162
- Group of Three Enquiry Stations164
Multi-Company Variant166
- Configuring the Multi-Company Variant167
- Activating the Multi-Company Variant167
- Configuring and Managing Companies168
- Assigning Users168
- Assigning Trunk Groups/Sip Accounts169
- Allocating Routing Codes169
- Configuring the Company Exchange170
- Working with the Multi-Company Variant170
- Company Telephone Book170
- Making Calls between Companies171
- Billing Charges Per Company171
Configuring the PC Software172
- PC Offline Configuration172
- Setting up TAPI174
- Setting up NET CAPI176
- Using the Systray Display177
- Browser for Opencti and Openhotel178
- Setting up Video Telephony179
- Synchronising the PC Clock180
- Address Queries Using LDAP181
Configuration Guide183
- Overview184
- PBX Ports185
- Lan186
- WAN Settings187
- RAS Settings188
- Branch Settings189
- E-Mail Function190
- E-Mail Access191
Frequently Asked Questions192
- General/Hardware192
- Telephony193
- Dect195
- Lan196
- Internet198
Technical Data200
Notes on Disposal203
Index204