Aastra OpenCom 510 - Saving and Loading the Configuration; Receiving System Messages as E-Mail

Configuration Configuring the OpenCom 510
96
Example
Enter:
H*1830000 *192*168
*99*254#
If required, initiate a system restart with this procedure:
H * 1 8 5 Z (system PIN) #
Use the PIN you entered in the dialogue box for initial access. The factory setting is
“0000”.
8.2.9 Saving and Loading the Configuration
Configurations are saved in a file archive and can be loaded to the OpenCom 510
either locally from a connected configuration PC, or by remote configuration.
The following configuration and customer data can be saved and loaded again:
■ Telephony and network parameters
■ User data
■ Telephone book entries
■ LCR tables
For further information, refer to the online help documentation under the topic
SYS Configuration: Data backup.
8.2.10 Receiving System Messages as E-Mail
Important events and errors are kept by the OpenCom 510 in an internal log book:
the error store. To inform or alert the system administrators, entries in the log book
(system messages) can be sent via e-mail.
In order not to notified of every error, the administrator can define corresponding
log filters (in the Configurator, the LOG Configuration: LOG Filter menu). These
filters define which errors (category, severity, number per time interval) should be
notified. The e-mails always include an internal event or error number, as well as an
explanation of the message. Further, extra parameters (such as the port number
when a trunk line drops out) are also provided.