Configuration Configuring the OpenCom 510
94
■ User name: “Administrator”
■ Password: [administrator password]
Note: If you do not wish to let the customer service centre/
authorised dealer know the administrator password, you can
define a temporary password for remote configuration with
at least five digits.
Use the following code digit procedure on a standard terminal or a system tele-
phone to activate internal remote maintenance access for the service centre/
authorised dealer:
Remote configuration on (log-on with administrator password)
H * 1 9 * Z (system PIN) #
Remote configuration on (log-on with temporary password)
H * 1 9 * Z (system PIN) * Z (temporary password) #
Remote configuration off
H # 1 9 #
Activation is automatically cancelled 30 minutes after the last configuration
activity.
Note: During remote configuration, the OpenCom 510 is
blocked for RAS access by any further users.
Please note: The system PIN is preset to “0000” and it is absolutely impe-
rative that the system administrator changes it to prevent
undesirable remote maintenance.
Using remote configuration, all OpenCom 510 settings (with the exception of the
system PIN) can be edited or updated. New software versions of the OpenCom 510
and the software for the connected system terminals and base stations can also be
installed (see the SYS Configuration: Firmware menu in the Configurator).
For security reasons, settings in the Configurator, Net Configuration should only
be edited on site to avoid malfunctions or failures in the customer’s LAN (e.g. due
to IP address conflicts). Refer to the chapter entitled Configuration Examples
starting on page 99, where interaction between the OpenCom 510 and a LAN is
explained.
To Next Page
Loading...