ABB AC-AP Series - Status LED; USB Connector

22 Control panel overview
Key shortcuts
The table below lists key shortcuts and combinations. Simultaneous key presses are
indicated by the plus sign (+).
 Status LED
The control panel has a status LED that indicates if there are any faults or warnings
present. The table below shows the meaning of the LED indications.
For further information on fault and warning indications, see Identifying error and
warning messages (page 57).
 USB connector
The USB connector is used for connecting the control panel to a PC. When
connected, the control panel acts as an USB adapter for data transfer between the
PC tool and the drive. It is also possible to transfer data between the PC and the
control panel through the USB connection.
Shortcut Available in... Effect
+ + any view Save a screenshot. Up to fifteen images can be stored
in the control panel memory. For instructions on how to
transfer the images into a PC, see section Transferring
files between the control panel and a PC (page 66).
+ ,
+
any view Adjust backlight brightness.
+ ,
+
any view Adjust display contrast.
or Home view Adjust reference.
+ parameter edit
views
Revert an editable parameter to its default value.
+ any view Show/hide parameter index and parameter group
numbers.
(keep down)
any view Return to Home view by pressing down the key until
Home view is shown.
Green, continuous The drive is functioning normally.
Green, flickering Data is transferred between the PC tool and drive through the USB
connection of the control panel.
Green, blinking There is an active warning in the drive.
Red, continuous There is an active fault in the drive.
Blue, blinking Bluetooth interface is enabled.It is in discoverable mode and ready
for pairing.
Blue, flickering Data is transfered through the Bluetooth interface of the control
panel.