38 Functions in the main Menu
Editing bit-field parameters
A bit-field parameter is a bit word whose individual
bits can be edited. The labels describe the function
of each bit, and the current state of the bit is shown
as 1 or 0.
• Use and to select a bit.
• To change a bit value, press or .
• To save the bit values and exit, press
(Save).
• To cancel and exit, press (Cancel).
Editing texts
Texts that you can edit with the control panel
include parameter display names in the Home view
and their units, drive names, fault and warning
names, and other customizable notes or names.
• To select the character mode ((lower case /
upper case / numbers / special characters),
press
unit symbol is highlighted
and then
select the mode with and .
Now you can start adding characters. The
mode remains selected until you select
another one.
• To add a character, highlight it with
and then press .
• To remove a letter, press
.
• Press (Save) to accept the new
setting, or press
(Cancel) to go back
to the previous view without making
changes.
Note: The current software version supports only
the English character set (a...z).
Resetting counters
Counters are parameters that measure incremental quantities associated with the
use of the drive such as runtime or energy consumption. Counters are updated
automatically and cannot be edited, but it is possible to reset a counter to zero by
pressing down (Reset) for three seconds.
Note: If a trigger value is defined for the counter, the counter’s progress from zero to
the trigger value is shown as a bar graph.
To Next Page
Loading...
