Functions in the main Menu 37
To select a parameter, follow the instructions:
1. Select Other to move to a list of parameter
groups.
2. Select a parameter group to move to a list of
parameters.
3. Depending on the parameter you are editing,
you must select a parameter or an individual bit,
or you may choose either of the two.
• If the right softkey label is Select, you must
select an individual bit as the value of the
parameter you are editing. Press
(Select) to move to a bit selection list.
• If the right softkey label is Save, you can
select that parameter as the value of the
parameter you are editing. Press
(Save) to save the selection.
• If the right softkey label is Save and there is
also an arrow on the right hand side of the
selection, you can choose an individual bit or
all the bits in that parameter. Press to
move to a bit selection list. If you want select
all the bits in the parameter, press
(Save) instead.
4. Select a bit if applicable (see the previous step).
Press to invert the selected bit and press
(Save) to save the selection.
The parameter or bit is now selected as the
parameter value.
To Next Page
Loading...
