62 Service and maintenance
Cleaning the connectors
Control panel has two connectors, RJ-45 connector (panel back side) and USB
connector (panel front side). Clean outside/around the connectors using suitable
cleaning solution (for example, Isopropyl Alcohol (IPA) solution). Do not use the
cleaning solution to clean inside the connectors.
Replacing the battery
The instructions below describe how to replace the battery that powers the real-time
clock of the control panel.
1. Turn the lid on the back of the control panel counter-clockwise until the lid opens.
2. Remove the battery gently.
3. Replace the battery with a new CR2032 battery. The battery holder has grip nails.
First slide the battery and then press on the other side. The battery will snap in.
4. Make sure that battery polarity shows positive on the upside.
5. Put the lid back and tighten it by turning it clockwise.
6. Dispose of the old battery according to local disposal rules or applicable laws.
Control panel software updates
If the control panel software needs to be updated, contact ABB.
Recycling instructions and environmental information
See the drive related Recycling instructions and environmental information.
To Next Page
Loading...
