58 Fault tracing
Refer to the table below to identify faults and warnings.
Display LED Type
continuous red See Faults (page 59).
blinking red Faults of this type require stopping and
restarting the drive before it continues to
function normally.
See Faults (page 59).
continuous red A fault has occurred in another drive in the
panel bus.
blinking green See Warnings (page 59).
continuous green The connection between the control panel
and the drive is faulty.
Check that the connection cable is
properly attached.
continuous green The control panel type is not compatible
with the drive you attempt to use it with.
See Compatibility (page 10).
continuous green The connection between the control panel
and the drive has been lost.
Check the control panel network
connections.
Select another drive.
To Next Page
Loading...
