1. Under “Application” open “Library Manager”.
2. Select “Add Library”.
ð
A list of all available libraries is displayed.
Libraries in folder “ABB - AC500” are created by ABB and tested in combination with
Automation Builder.
We recommend to use libraries of subfolder “Use Cases” for your project.
Libraries in subfolder “Intern” are necessary for internal procedures.
All 3S libraries distributed with Automation Builder are required by ABB libraries and
have been tested in combination with AC500 and Automation Builder. Additional 3S
libraries that are not distributed with Automation Builder can easily be added. There
are no known major issues with using them, however, be aware that they are not
tested by ABB.
3. Add a library.
4. Choose the added library in Library Manager to access the documentation.
The function block description is shown as an example as follows.
Function block description > Use the onboard I/Os as output PWM (pulse-width modulation)
2021/06/29 3ADR010635, 2, en_US 189
To Next Page
Loading...
