166 Parameter listing and descriptions
ACH550-01 User's Manual
• Group 21: START/STOP – Defines how the motor starts and
stops.
• Group 22: ACCEL/DECEL – Defines ramps which control the
rate of acceleration and deceleration.
• Group 23: SPEED CONTROL – Defines variables for speed
control.
• Group 25: CRITICAL SPEEDS – Defines critical speeds or
speed ranges.
• Group 26: MOTOR CONTROL – Defines motor control
variables.
• Group 29: MAINTENANCE TRIG – Defines usage levels and
trigger points.
• Group 30: FAULT FUNCTIONS – Defines faults and
responses.
• Group 31: AUTOMATIC RESET – Defines conditions for
automatic resets.
• Group 32: SUPERVISION – Defines supervision for signals.
• Group 33: INFORMATION – Contains software information.
• Group 34: PANEL DISPLAY – Defines the content for control
panel display.
• Group 35: MOTOR TEMP MEAS – Defines motor
overheating detection and reporting.
• Group 36: TIMED FUNCTIONS – Defines timed functions.
• Group 37: USER LOAD CURVE – Defines user adjustable
load curves.
• Group 40: PROCESS PID SET 1 – Defines a process PID
control operation mode for the drive.
• Group 41: PROCESS PID SET 2 – Defines a process PID
control operation mode for the drive.
• Group 42: EXT / TRIM PID – Defines parameters for External
PID.
• Group 45: ENERGY SAVING - Defines the setup of
calculation and optimization of energy savings.
• Group 51: EXT COMM MODULE – Defines set-up variables
for external fieldbus communication module (FBA).
• Group 52: PANEL COMM – Defines set-up variables for
panel communication.
• Group 53: EFB PROTOCOL – Defines set-up variables for
embedded fieldbus communication protocol.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
