ABB ACH550-01 - Preparing the Mounting Location

38 Installing the drive
ACH550-01 User's Manual
Preparing the mounting location
1. Use the mounting
template to mark the
position of the mounting
holes.
2. Drill the holes.
3. Insert the screws halfway
into the holes.
Note: Frame sizes R3 and R4 have four holes along the top.
Use only two. If possible, use the two outside holes (to allow
room to remove the fan for maintenance).
1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com