442 Technical data
ACH550-01 User's Manual
Applicable standards
Drive compliance with standards is identified by the standard
“marks” on the type designation label. The following standards
are applicable to the drive:
Markings
CE marking
A CE mark is attached to the drive to verify that the
drive follows the provisions of the European Low
Voltage, EMC and RoHS Directives.
Applicable standards
EN 50178:1997 Electronic equipment for use in power
installations.
IEC/EN 60204-
1:2005
Safety of machinery. Electrical
equipment of machines. Part 1: General
requirements. Provisions for
compliance: The final assembler of the
machine is responsible for installing:
• an emergency-stop device
• a supply disconnecting device.
IEC/EN 60529:1989
+ A1:1999
+A2:2013
Degrees of protection provided by
enclosures (IP code)
IEC 60664-1:2002 Insulation coordination for equipment
within low-voltage systems. Part 1:
Principles, requirements and tests
IEC/EN 61000-3-
12:2011
EMC standard limiting harmonic
currents produced by equipment
connected to public low-voltage
systems
IEC/EN 61800-5-
1:2007
Adjustable speed electrical power drive
systems. Part 5-1: Safety requirements.
Electrical, thermal and energy
IEC/EN 61800-
3:2004 +A1:2012
Adjustable speed electrical power drive
systems. Part 3: EMC requirements and
specific test methods
UL 508C UL Standard for Safety, Power
Conversion Equipment, third edition
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
