10 CDP CONTROL PANEL
3BHS213401 E01 REV H ACS1000 AIR-COOLED USER MANUAL 130/184
10.2 CDP control panel functions
The CDP control panel serves as the basic user interface for operating and monitoring the drive
when the local operating mode has been selected.
The CDP control panel can be attached to or detached from the drive without having to switch
off the auxiliary power supply first.
You can perform the following tasks with the CDP control panel:
- Enter start-up data
- Control the drive with a reference value, and start, stop and direction commands
- Display actual values (three values can be read simultaneously)
- Display and adjust parameters
- Display information on the most recent forty fault events
- Upload and download complete parameter sets from one drive to another
10.3 CDP control panel modes
The CDP control panel provides the following modes:
- “10.3.1 Identification mode” on page 130
- “10.3.2 Actual signals mode” on page 132
- “10.3.3 Parameters mode” on page 139
- “10.3.4 Functions mode” on page 144
10.3.1 Identification mode
The identification mode informs the user about the CDP control panel version and the ID
number of the drive. The information appears on the display when the:
- Power supply is switched on
- CDP control panel is connected to the drive and the auxiliary voltage has already been
switched on.
When the CDP control panel is initialized as described before, the display changes as follows:
CDP312 PANEL V5.30
........
To Next Page
Loading...
