ABB ACS580MV - Preparing the Cable Entry and the Cables; Determining the Cable Length; Routing the Cables

80 Electrical installation
• Dimensions between point of cable entry and terminals
See ACS580MV Wiring Diagram for information on:
• Conventions for cross-references and device identification
• Terminal designations
 Preparing the cable entry and the cables
Determining the cable length
1 Determine the required length of a cable between the point of entry and the connection
point inside the cabinet.
2 Cut the cable to the required length before connection.
Routing the cables
• Route the cables as illustrated through the provided cable duct to the customer
terminals or fieldbus modules in the control compartment.
Duct for auxiliary and control cables (1)
1