ABB ACS580MV - Cable Entries for External Connections; Power Cable Entry Via Holes in Cable Entry Plate; Control and Auxiliary Cable Entry with EMC Plates

Electrical installation 71
For further information on locating the temperature sensor cables, auxiliary power supply
cables and the optional heating cable, see ACS580MV Wiring Diagram.
Cable entries for external connections
Power cable terminals are located in the terminal compartment behind the control
compartment. They can be accessed after removing the metal cover (tripping loop
terminals -XS1 on the cover must be opened first).
The drive is prepared for top or bottom cable entry with one or a combination of the following
cable entries:
• Metal plate hole cable entry for power cables, ground cables
• Cable entry with EMC plates, EMC cushions and sealing grommets for auxiliary and
control cables
For detailed information e.g. location and dimensions, see ACS580MV Base frame & TEU
layout design.
 Power cable entry via holes in cable entry plate
Power cable entry can be from bottom or top.
Galvanized plate for cable entry.
Plate mounted on top. See Sealing holes in entry plates for more information.
 Control and auxiliary cable entry with EMC plates
Cable entry can be from bottom or top.
1
2
3
1 Power cable entry plate (in TEU)
2 Auxiliary and control cable entry (in COU)
3 Sealing compound