Technical data
100
Second environment
The drive complies with the limits of IEC 61800-3 with the following provisions:
1. It is ensured that no excessive emission is propagated to neighbouring low-voltage networks. In
some cases, the natural suppression in transformers and cables is sufficient. If in doubt, the supply
transformer with static screening between the primary and secondary windings is strongly
recommended.
2. The drive is installed according to the instructions given in the Hardware Manual.
3. The motor and control cables used are selected as specified in the Hardware Manual.
Equipment warranty and liability
The manufacturer warrants the equipment supplied against defects in design, materials and
workmanship for a period of twelve (12) months after installation or twenty-four (24) months from date
of manufacturing, whichever first occurs. The local ABB office or distributor may grant a warranty period
different to the above and refer to local terms of liability as defined in the supply contract.
The manufacturer is not responsible for
• any costs resulting from a failure if the installation, commissioning, repair, alternation, or ambient
conditions of the drive do not fulfil the requirements specified in the documentation delivered with
the unit and other relevant documentation.
• units subjected to misuse, negligence or accident
• units comprised of materials provided or designs stipulated by the purchaser.
In no event shall the manufacturer, its suppliers or subcontractors be liable for special, indirect,
incidental or consequential damages, losses or penalties.
If you have any questions concerning your ABB drive, please contact the local distributor or ABB office.
The technical data, information and specifications are valid at the time of printing. The manufacturer
reserves the right to modifications without prior notice.
Low voltage
Equipment
Low voltage
Equipment
Equipment
(victim)
Supply transformer
Medium voltage network
Static screen
Point of measurement
Drive
Neighbouring network
To Next Page
Loading...
Need help?
General
