Technical data
96
Materials
Drive enclosure • PC/ABS 2.5 mm, colour NCS 1502-Y (RAL 90021 / PMS 420 C)
• hot-dip zinc coated steel sheet 1.5 to 2.5 mm, thickness of coating 100 micrometres,
colour NCS 1502-Y
Package plywood and wood. Plastic covering of the package: PE-LD, bands PP or steel.
Disposal The drive contains raw materials that should be recycled to preserve energy and natural
resources. The package materials are environmentally compatible and recyclable. All metal
parts can be recycled. The plastic parts can either be recycled or burned under controlled
circumstances, according to local regulations. Most recyclable parts are marked with
recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors and printed circuit boards
can be landfilled. The DC capacitors (C1-1 to C1-x) contain electrolyte and the printed circuit
boards contain lead, both of which will be classified as hazardous waste within the EU. They
must be removed and handled according to local regulations.
For further information on environmental aspects and more detailed recycling instructions,
please contact your local ABB distributor.
Applicable standards
The drive complies with the following standards. The compliance with the European Low
Voltage Directive is verified according to standards EN 50178 and EN 60204-1.
• EN 50178 (1997) Electronic equipment for use in power installations
• EN 60204-1 (1997) Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device.
• EN 60529: 1991 (IEC
529)
Degrees of protection provided by enclosures (IP code)
• IEC 60664-1 (1992) Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
• EN 61800-3 (1996) +
Amendment A11 (2000)
EMC product standard including specific test methods
• UL 508C UL Standard for Safety, Power Conversion Equipment, second edition
• CSA C22.2 No. 14-95 Industrial control equipment
To Next Page
Loading...
