ABB ACS800-02 - Routing Control;Signal Cables (No Enclosure Extension)

Installation
64
Routing the control/signal cables inside the cubicle
Units without an enclosure extension
Frame size R7
Secure the
cables with
cable ties to
these holes.
Secure the
cables with
cable ties to
the holes in
the side
bracket of the
capacitor
pack.
Lead the
cables through
the cushions.
This is for
mechanical
support only.
(No 360
degrees EMC
grounding is
needed here.)
Place for user’s motor
temperature relay
RMIO
Opening the
top front
cover (R7)
Disconnect the
control panel cables.
Place for user’s motor
temperature relay
Frame size R8