ABB ACS850-04 - Start;Stop

Parameters 109
09.20 Option slot1 Displays the type of the optional module in option slot 1.
0 = No option, 1 = No comm, 2 = Unknown, 3 = FEN-01,
4=FEN-11, 5=FEN-21, 6=FIO-01, 7=FIO-11,
8 = FPBA-01, 9 = FPBA-02, 10 = FCAN-01, 11 = FDNA-01,
12 = FENA-01, 13 = FENA-02, 14 = FLON-01,
15 = FRSA-00, 16 = FMBA-01, 17 = FFOA-01,
18 = FFOA-02, 19 = FSEN-01, 20 = FEN-31, 21 = FIO-21,
22 = FSCA-01, 23 = FSEA-21
1 = 1
09.21 Option slot2 Displays the type of the optional module in option slot 2. See
signal 09.20 Option slot1.
1 = 1
09.22 Option slot3 Displays the type of the optional module in option slot 3. See
signal 09.20 Option slot1.
1 = 1
10
10 Start/stop
Start/stop/direction etc. signal source selections.
10.01 Ext1 start func Selects the source of start and stop commands for external
control location 1 (EXT1).
Note: This parameter cannot be changed while the drive is
running.
Not sel No start or stop command sources selected. 0
In1 The source of the start and stop commands is selected by
parameter 10.02 Ext1 start in1. The state transitions of the
source bit are interpreted as follows:
1
3-wire The sources of the start and stop commands is selected by
parameters 10.02 Ext1 start in1 and 10.03 Ext1 start in2. The
state transitions of the source bits are interpreted as follows:
2
FBA The start and stop commands are taken from the fieldbus. 3
D2D The start and stop commands are taken from another drive
through the D2D (Drive-to-drive) Control Word.
4
In1F In2R The source selected by 10.02 Ext1 start in1 is the forward
start signal, the source selected by 10.03 Ext1 start in2 is the
reverse start signal.
5
In1St In2Dir The source selected by 10.02 Ext1 start in1 is the start signal
(0 = stop, 1 = start), the source selected by 10.03 Ext1 start
in2 is the direction signal (0 = forward, 1 = reverse).
6
No. Name/Value Description FbEq
State of source
(via par 10.02)
Command
0
-
> 1 Start
1
-
> 0 Stop
State of source 1
(via par. 10.02)
State of source 2
(via par. 10.03)
Command
0
-
> 1 1 Start
Any 1
-
> 0 Stop
Any 0 Stop
State of source 1
(via par. 10.02)
State of source 2
(via par. 10.03)
Command
00Stop
1 0 Start forward
0 1 Start reverse
11Stop