C-6 CE Guidelines 3AXD50000011888
C.4.2 CSA Marking
The drives of frame sizes R1 to R3 are CSA marked. The CSA marking is pending for the other frames. The approval is valid
with rated voltages.
C.4.3 “C-tick” Marking
“C-tick” marking is required in Australia and New Zealand. A “C-tick” mark is attached to the 380…500V drives to verify
compliance with the relevant standard (IEC 61800-3:2004), mandated by the Trans-Tasman Electromagnetic Compatibility
Scheme. C-tick marking is pending for drives of voltage ranges 204…240V and 525…690V.
For fullling the requirements of the standard, see section Compliance with the EN61800-3:2004 in hardware manual.
C.5 GOST R Certificate of Conformity
The drive has been given a GOST R certicate of conformity.
C.6 Disclaimer
The manufacturer shall have no obligation hereunder with respect to any product which (i) has been improperly repaired
or altered; (ii) has been subjected to misuse, negligence or accident; (iii) has been used in a manner contrary to the
Manufacturer’s instructions; or (iv) has failed as a result of ordinary wear and tear.
To Next Page
Loading...
