Control Wiring 6-53AXD50000011888
6.4 ACS880+N5350 Relay Outputs
The ACS880+N5350 has the ability of reporting multiple internal states to the user by the use of relay outputs. For example,
a relay can be set up to illuminate an external indicator light should the drive fault.
Three Form-C relay outputs are provided in the ACS880+N5350.
The functions of the relay outputs are selected by parameters 10.24 RO1 Source, 10.27 RO2 Source and 10.30 RO3 Source.
For details on setting the Relay Output function see the ACS880 software manual.
Figure 6-3 depicts connections to the digital outputs for the various ways they can be used.
Figure 6-3 Relay Outputs
XR01, XR02, XR03 Relay outputs
1
2
3
1
2
3
1
2
NC
COM
NO
NC
COM
NO
NC
COM
3 NO
Ready
250 VAC / 30 VDC
2 A
Running
250 VAC / 30 VDC
2 A
Faulted (-1)
250 VAC / 30 VDC
2 A
Table 6-3 Relay Output Technical Data
Relay outputs RO1…RO3 (XRO1…XRO3)
Connector pitch 5mm, wire size 2.5mm
2
250VAC / 30VDC, 2A
Protected by varistors
+24V output (XD24:2 and XD24:4)
Connector pitch 5mm, wire size 2.5mm
2
Total load capacity of these outputs is 4.8W (200mA / 24V)
minus the power taken by DIO1 and DIO2.
To Next Page
Loading...
