ABB ACS880-01-061A-3+N5350 - First Start-Up

8-2 Keypad and Programming 3AXD50000011888
8.1.2 First Start-Up
The following instructions explain how to start up the control panel for the rst time.
1. Make sure that all drive-specic safety precautions have been taken into account.
2. Install the control panel as instructed in Installation.
3. Power up the drive.
The control panel start-up begins automatically. Wait until the control panel enters the language selection view.
Note: The language selection view only appears during the rst start-up of the control panel, but it is possible to change the
language later in the Settings menu (see parameter 96.01) or with the set-up assistant.
Figure 8-2
English
Deutsch
Italiano
Espa
ň
ol
Portugues
Nederlands
Fran
ç
ais
OK
4. Use or to select a language.
5. Press (OK) to conrm your selection.
Wait until the control panel completes uploading the language le. Its progress is indicated by a progress bar.
Figure 8-3
ACS880
Cooling Tower Drive
ACS880
There is a Basic set-up assistant in the drive that the control panel prompts to begin the Cooling Tower Assistant. Details on
the assistant are contained in Chapter 12 of this manual.
Figure 8-4
00:00 ContinueExit
CTDD 0.0 rpmRemote
Cooling Tower Direct ...
Use arrow keys and soft keys to
Navigate the assistant
Completing the assistant or Exiting returns you to the Home view. Once you are in the Home view, the control panel is ready
for use.
Figure 8-5
00:00 MenuOptions
CTDD 0.0 rpmLocal
0.00
Motor speed used rpm
0.00
Motor current A
To return to the assistant screen, select Menu  Assistants  CTDD Setup.
Press Select to launch the assistant.