ABB ACS880-01-061A-3+N5350 - Fieldbus Operating Mode

9-4 Operating Modes 3AXD50000011888
9.4 Fieldbus Operating Mode
The drive can be connected to an external control system through an optional eldbus adapter mounted onto the control
unit of the drive or via the Embedded Fieldbus (D2D Port – MODBUS – RTU Protocol). When Fieldbus Operating Mode is
selected, the drive Starts and Stops using the Main Command Word, (6.01) bit 2, if DI2 is on for Remote Fieldbus Control.
DI2(1) also selects FBA Ref1 as the speed reference. The drive actually has two independent interfaces for eldbus
connection called “eldbus adapter A” (FBA A) and “eldbus adapter B” (FBA B). Fieldbus adapters are available for various
communication systems and Industrial Protocols, for example:
Fieldbus Adapters
FDNA-01 DeviceNet™ Adapter K451
FPBA-01 PROFIBUS DP Adapter K454
FCAN-01 CanOpen Adapter K457
FSCA-01 Modbus Adapter, comes with a price when Built-in Modbus K458
FCNA-01 ControlNet™ Adapter K462
FECA-01 EtherCAT Adapter K469
FEPL-02 Ethernet Powerlink Adapter K470
FENA-21 Two-Port Ethernet Adapter (EtherNet/IP™, Modbus/TCP,
PROFINET IO)
K475
FEIPO-21 Ethernet/IP K490
FMBT-21 Modbus TCP/IP K491
FPIO-21 Pronet I/O K492
NOTES:
• Only Fieldbus Adapter A (FBA A or embedded Fieldbus (EFB) can be used to control
the drive.
• Only the transparent 16 prole can be used with the ACS880+N5350 drive due to
the fact that additional control word bits and status word bits are used in the CTDD
Application that are not supported in other proles.