ABB ACS880-01-061A-3+N5350 - Home View; Help; Common User Tasks

Keypad and Programming 8-93AXD50000011888
8.4.3 Home View
The main view of the control panel is called the Home view. In the Home view, you can monitor the status of the drive, such
as its speed, torque or power. The Home view has nine pages, each of which can display a set of signals.
In the example below, three Home view pages are used, showing different display formats.
Figure 8-12
00:00 MenuOptions
ACS880 CTDD 0.0 RpmLocal
0.0
0.0
Motor speed
Rpm
Motor current
A
00:00 MenuOptions
0.0
0.0
Motor volts
V
0.0
ACS880 CTDD 0.0 RpmLocal
Motor speed
Rpm
Motor current
A
00:00 MenuOptions
Output Power
ACS880 CTDD 0.0 RpmLocal
DC Voltage
Drive temperature
-32768.0 32768.0
-40 160
0 800
618.31V
14.5%
0.0 kW
The Home view opens automatically when you power up the drive. The Home view is also displayed from the Options menu
or the main Menu if no key is pressed for 10 minutes.
Tip: You can return to the Home view from any view except special screens by holding down the left softkey .
8.4.3.1 Navigating in the Home View
• Use and to move between the different pages of the Home view. The page numbers are shown while you scroll
between pages.
• Use or to adjust the reference (visible in the top right corner).
• Press (Menu) to open the main Menu.
• Press (Options) to open the Options menu.
8.4.4 Help
You can open a context-sensitive help page in all menus and views by pressing
?
. The help page provides information on
the use of the current view or menu, or on possible problems associated with it.
On the help page, you can:
•Press
?
again or (Exit) to exit.
8.4.5 Common User Tasks
This following tables list common user tasks and describes how to complete them.
8.4.5.1 Basic Operation of the Drive
Table 8-5
Task Actions
Start and stop the drive.
In local control, press to start the drive and to stop
the drive.
Set the reference (for example, speed) in the Home view.
In local control, go to Options > Reference. Set the reference
with the arrow keys.
Switch between local and remote control.
Press
Loc/Rem
.
Change the direction of motor rotation.
In local control, go to the Home view, press (Options) to
open the Options menu and select Direction change.