Startup Assistant & Parameters 12-13AXD50000011888
Chapter 12
Startup Assistant & Parameters
12.1 Startup Assistants Guide for ACS880+N5350
This chapter describes the basic start-up assistants for motor data and ID run; and setting up the ACS880 drive equipped
with +N5350 cooling tower program. In this guide, the drive is set up using the ACS-AP-I control panel. Complete
documentation of the drive rmware can be found in Firmware manual, 3AUA0000085967.
Never work on the drive, the braking chopper circuit, the motor cable or the motor when power is applied to the drive.
Always ensure by measuring that no voltage is actually present.
Note: Before you start ensure that the drive has been mechanically and electrically installed as described in the appropriate
sections of this manual.
WARNING: All electrical installation and maintenance work on the drive should be carried out by qualied electricians.
12.1.1 Motor Data and ID Run
On initial startup, the drive automaticlly goes into the Motor data setup.
Table 12-1 Initial Start-up / Motor Data and ID Run
Safety
The start-up may only be carried out by a qualied electrician.
The safety instructions must be followed during the start-up procedure. See the safety instructions on the rst
pages of the appropriate Hardware manual.
Check the installation. See the installation checklist in the appropriate Hardware manual.
Check that the starting of the motor does not cause any danger.
De-couple the driven machine if there is a risk of damage in case of an incorrect direction of rotation.
Power-Up, Date and Time Settings
Power up the drive.
On initial power up the cooling tower drive requests
a language selection for the setup process.
English
Deutsch
Italiano
Espa
ň
ol
Portugues
Nederlands
Fran
ç
ais
OK
Select language using and and press
(continue) to accept.
The drive will load the selected language; this may
take a few minutes.
ABB loading screen will appear after the language
selection completes.
ACS880
Cooling Tower Drive
ACS880
To Next Page
Loading...
