Keypad and Programming 8-13AXD50000011888
Chapter 8
Keypad and Programming
The ACS880+N5350 is supplied with a display combined with a keypad so that the status of the control can be monitored
and parameters can be programmed. Additionally, the keypad can be used to control the cooling tower fan locally. This
keypad can be left on the front cover of the drive, but is not required to operate the drive in the remote mode where control
is accomplished using the drive terminal strip or via a network communications card.
8.1 Installation and Start-Up
This section describes how to install and start up the Assistant control panel for the rst time.
8.1.1 Installation
You can attach the control panel directly to the drive or use a separate mounting kit (for example, for cabinet door mounting).
To attach the control panel,
1. place its bottom end into the bottom of the slot in the drive (A),
2. pivot the control panel and push the upper part (B) until you hear a click.
To detach the control panel,
1. release the control panel by pressing the clip (B),
2. pull the upper end of the control panel out of the slot in the drive.
Figure 8-1
To Next Page
Loading...
