12-4 Startup Assistant & Parameters 3AXD50000011888
Table 12-1 Initial Start-up / Motor Data and ID Run
Highlight the desired unit with the and press
(next).
Use to move between the units. Use to
select the value for editing.
Pressing (save) returns to the unit selection
menu.
Unit Selection
Tariff currency unit
AI1 unit selection
00:00 NextBack
CTDD 0.0 rpmLocal
Units
Change the display units if needed.
0000 0000 0001 00011
USD
V
Supply Voltage Settings
Press to edit the supply voltage input to the
CTDD drive.
Note: For 460...480 V, it is recommended that supply
voltage is set to 500 V.
Supply voltage
00:00 NextBack
CTDD 0.0 rpmLocal
Supply voltage
Set supply voltage.
500 V
Motor Data Settings
Refer to the motor nameplate for the following parameter settings. Whenever possible, enter the values exactly as
shown on the motor nameplate.
Example of a nameplate of a Back-EMF motor:
MEASURED OPEN CIRCUIT VOLTAGE
IS
VOLTS AT RPM.
MOTOR PHASE CURRENT SHOULD NOT
EXCEED
AMPS RMS PEAK TO
AVOID DEMAGNETIZATION.
000692-000VY
PERMANENT MAGNET MOTOR
WHEN SHAFT IS ROTATED, VOLTAGE WILL BE
GENERATED AT THE MOTOR TERMINALS.
WARNING
patent US 7,385,328
Example of a nameplate of a permanent magnet motor:
000613-006AAP
DUTY HP RPM AMPS VOLTS HZ
PLANT 15
ENCL. MOD.
SER. NO.
S.F.
DESIGN NO.
PH.
D.E.
BRG.
O.D.E.
BRG.
MAX. SAFE
AMB. MIN. AMB.°C °C
FR. INSUL
ENCL.
SPEED
TYPE
MINIMUM AIRFLOW VELOCITY FT. PER MINUTE
PATENT US 7,880,348 B2
CAT
NO.
SPEC
NO.
LR40567
C US
R
TM
To Next Page
Loading...
