140 Technical data
Efficiency
96.0 … 98.0% at nominal power level depending on drive type
Protection classes
Degrees of protection
(IEC/EN 60529)
IP22 (standard), IP42 (optional),IP54(pending)
Overvoltage category
(IEC 60664-1)
III
Protective class
(IEC/EN 61800-5-1)
I
Ambient conditions
Environmental limits for the drive are given below. The drive is to be used in a heated, indoor, controlled
environment.
Operation
installed for stationary
use
Storage
in the protective package
Transportation
in the protective package
Installation site altitude 0 to 2000 m above sea
level.
For attitude over 2000m,
contact ABB.
Output derated above
1000 m (3281 ft). See
section The ratings of the
drive modules with 50 Hz
and 60 Hz supply are
given below..
--
Air temperature 0 … +40 °C
(+32 … +104 °F). No
condensation allowed.
Output derated in the
range +40 … +50 °C
(+104 … +122 °F). See
section The ratings of the
drive modules with 50 Hz
and 60 Hz supply are
given below..
-40 to +70 °C
(-40to+158°F)
-40 to +70 °C
(-40to+158°F)
Relative humidity Max. 95% Max. 95% Max. 95%
No condensation allowed. Maximum allowed relative humidity is 60% in the
presence of corrosive gases.
Contamination IEC/EN 60721-3-3:2002:
Classification of
environmental conditions
- Part 3-3: Classification
of groups of
environmental
parameters and their
severities - Stationary
use of weather protected
locations
IEC 60721-3-1:1997 IEC 60721-3-2:1997
Chemical gases Class 3C2 Class 1C2 Class 2C2
Solid particles Class 3S2. No
conductive dust allowed.
Class 1S3 (packing must
support this, otherwise
1S2)
Class 2S2
To Next Page
Loading...
