ABB ACSM1 Series User Manual

103
140
Cannot change mode to TORQUE (frequency is used)
150
Internal buffer overflow
160
Internal communication error
DP-V1 error table
Error no.
Meaning
Used at
00h
Impermissible parameter number
Access to unavailable parameter
01h
Parameter value cannot be changed
Change access to a parameter value that
cannot be changed
02h
Low or high limit exceeded.
Change access with value outside the limits.
03h
Invalid subindex
Access to unavailable subindex
04h
No array
Access with subindex to non-indexed
parameter
05h
Incorrect data type
Change access with value that does not match
the data type of the parameter
06h
Setting not permitted (can only be reset)
Change access with value unequal to 0 when
this is not permitted
07h
Description element cannot be changed
Change access to a description element that
cannot be changed
09h
No description data available
Access to unavailable description (parameter
value is available)
0Bh
No operation priority
Change access rights without rights to change
parameters.
0Fh
No text array available
Access to text array that is not available
(parameter value is available)
11h
Request cannot be executed because of
operating mode
Access is temporarily not possible for reasons
that are not specified in detail
14h
Value impermissible
Change access with a value that is within limits
but is not permissible for other long-term
reasons (parameter with defined single values)
15h
Response too long
The length of the current response exceeds the
maximum transmittable length

ABB ACSM1 Series Specifications

General

Product Type	AC drive
Control Type	Scalar Control
Communication Interfaces	Modbus RTU
Protection Class	IP20
Mounting	Wall Mounting
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short Circuit
Storage Temperature	-40°C to +70°C
Input Voltage	380 V to 480 V AC
Operating Temperature	-10 to +40 °C (without derating)