ABB ACSM1 - Fan Replacement (Frames C and D, ACSM1-04 Cx-XXXX-X)

Maintenance
68
Fan replacement (Frames C and D, ACSM1-04Cx-xxxx-x)
Unfasten the fan holder by removing the two screws marked (1) in the drawing
below. Pull the fan holder out and disconnect the wire plug (2). Remove the four
screws (3) to release the fan from the holder. Use the spacers (4) to mount the new
fan.
Install new fan in reverse order.
Note: The airflow direction is bottom-to-top. Install the fan so that the airflow arrow
points up.
A
i
r
f
l
o
w
d
i
r
e
c
t
i
o
n
1
2
3
4