ABB ACSM1 - Technical Data; What this Chapter Contains; Ratings

Technical data
71
Technical data
What this chapter contains
This chapter contains the technical specifications of the drive, e.g. the ratings, sizes
and technical requirements, and provisions for fulfilling the requirements for CE and
other markings.
Ratings
The nominal current ratings for the ACSM1-04 with 400 V AC supply are given
below.
Drive type
ACSM1-04xx…
Frame
size
Input ratings Output ratings
I
1N
*I
1N
I
2N
I
2cont4k
I
2cont8k
I
2cont16k
I
2max
P
N
AAAAAAAkWHP
-02A5-4 A 1.9 3.2 2.5 3.0 2.5 2.0 5.3 0.75 1
-03A0-4 A 2.6 4.7 3.0 3.6 3.0 2.2 6.3 1.1 1.5
-04A0-4 A 3.3 5.7 4.0 4.8 4.0 2.4 8.4 1.5 2
-05A0-4 A 4.6 7.8 5.0 6.0 5.0 2.5 10.5 2.2 3
-07A0-4 A 5.8 9.8 7.0 8.0 5.5 3.0 14.7 3 3
-09A5-4 B 7.9 12 9.5 10.5 9.5 5.0 16.6 4 5
-012A-4 B 10 15 12 14 12 6.0 21 5.5 7.5
-016A-4 B 14 20 16 18 13 7.5 28 7.5 10
-024A-4 C 20 21 24 27 24 18 42 11 15
-031A-4 C 27 26 31 35 31 20 54 15 20
-040A-4 C 33 29 40 44 35 22 70 18.5 25
-046A-4 C 39 35 46 50 38 24 80 22 30
-060A-4 D 55 45 60 65 55 28 105 30 40
-073A-4 D 65 51 73 80 60 31 128 37 50
-090A-4 D 78 58 90 93 65 34 150 45 60
*Without mains choke
PDM-00425726
I
1N
Nominal input current (rms) at 40 °C (104 °F).
I
2N
Nominal output current at 40 °C (104 °F).
I
2contxk
Continuous output current at a switching frequency of 4/8/16 kHz at 40 °C (104 °F).
P
N
Typical motor power.
I
2max
Maximum short-time output current. See section Cyclic loads below.
Note: Frame sizes C and D can be used continuously without a mains choke at up to 50% of nominal
shaft power (i.e. at continuous nominal torque up to 50% of rated speed).
To achieve the rated motor power given in the table, the rated current of the drive must be higher than
or equal to the rated motor current.
The DriveSize dimensioning tool available from ABB is recommended for selecting the drive, motor
and gear combination for the required motion profile.