Technical data
80
Applicable standards
The drive complies with the following standards. The compliance with the European Low
Voltage Directive is verified according to standards EN 50178 and EN 60204-1.
• EN 50178 (1997) Electronic equipment for use in power installations
• IEC 60204-1 (2005),
modified
Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device
- the ACSM1-04 into a cabinet.
• EN 60529: 1991
(IEC 60529)
Degrees of protection provided by enclosures (IP code)
• IEC 60664-1 (2007), Edition
2.0
Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
• IEC 61800-3 (2004) Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods.
• EN 61800-5-1 (2003) Adjustable speed electrical power drive systems.
Part 5-1: Safety requirements. Electrical, thermal and energy
Provisions for compliance: The final assembler of the machine is responsible for installing
the ACSM1-04 in a cabinet that is protected to IP2X (IP3X for top surfaces for vertical
access).
• prEN 61800-5-2 Adjustable speed electrical power drive systems.
Part 5-2: Safety requirements. Functional
• UL 508C (2002), Third
Edition
UL Standard for Safety, Power Conversion Equipment
• NEMA 250 (2003) Enclosures for Electrical Equipment (1000 Volts Maximum)
• CSA C22.2 No. 14-05
(2005)
Industrial Control Equipment
To Next Page
Loading...
