ABB EasyLine EL3000 - Page 45

EL3000 CONTINUOUS GAS ANALYZERS | CI/EL3000-EN REV. C 45
Gas connections Uras26 (model EL3040)
Figure 6: Gas connections Uras26 (model EL3040)
Uras26: Gas connections
Pos.
Connection
Supplementary information
Version
1
Pressure sensor
The pressure sensor is connected to the
Pos. 1 terminal if
the internal gas lines are designed as stainless steel pipes,
or if the ‘Pressure sensor connected outside by hose’ option
is ordered.
⅛ NPT female thread (stainless steel 1.4305)
•
Connection of hose lines:
straight screw-in socket (PP) with
hose nozzles
for hoses with inside diameter 4 mm (included
in scope of delivery)
•
Connection of piping:
screw-in fittings (not included in scope of
delivery)
2
Not assigned
—
3
Sample gas inlet (gas path 1)
—
4
Sample gas outlet (gas path
1)
For a
measuring cell and for two measuring cells with
separate gas paths
5
Purge gas inlet (housing)
—
6
Purge gas outlet (housing)
—
7
Sample gas inlet (gas path 2)
—
8
Sample gas outlet (gas path 2)
—
Sample gas outlet (gas path 1)
For two sample cells in series
9
Reference gas inlet
Sample cell 1 flowing reference gas
10
Reference gas outlet
Note
• If the internal gas lines ares designed as hoses, the pressure sensor (standard, not for the ‘pressure sensor connected to outside
by hose’ option), and the oxygen sensor (option) are internally connected as follows:
– In the output of measuring cell 1, for one measuring cell and for two measuring cells with separate gas paths.
– In the output of measuring cell 2 for two measuring cells in a series.
– The second oxygen sensor (option for version with separate gas paths) is connected in the outlet of sample cell 2.
• If the internal gas lines are designed as stainless steel pipes, the oxygen sensor and the version with separated gas paths are not
possible.