ABB EC Titanium Series - Chapter 2 General Information and Ratings; Type Designation Key

General Information and Ratings 2-1MN448
Chapter 2
General Information and Ratings
This chapter contains information about the EC Titanium integrated motor and drive including how to identify the product,
general information and ratings.
2.1 Type Designation Key
The type designation contains information on the specications and conguration of the motor or the drive and motor
integrated unit. The type designation label is contained on the motor nameplate. The rst digits from left express the
basic conguration, followed by module type, voltage, speed and horsepower rating. Figure 2.5 shows the basic stock
congurations, refer table 2-3 for details on congured nomenclature.
Figure 2-1 Nomenclature
Voltage
0 = 230 V / 460 V
1 = 115V 1-Phase
2 = 230 V
4 = 460 V
8 = 230 V 1-Phase
Version
M = Motor Only
T = Top Mount Drive
A = Axial Mount Drive
Frame*
100 = Rolled Steel
101 = Plenum Use
Product Series
S = Standard
ECS 100 M 1 H --- D F 4
Horsepower
1 = 1 HP
2 = 2 HP
3 = 3 HP
5 = 5 HP
7 = 7.5 HP
10 = 10 HP
15 = 15 HP
20 = 20 HP
NEMA Frame
Mounting
F = Foot Mount
B = C-Face Foot
C = C-Face Footless
Enclosure TEFC
IMD & Motor IP54
Base Speed
2 = 3600 RPM
4 = 1800 RPM
6 = 1200 RPM
8 = 900 RPM
D = 140
E = 180
F = 210
J = 56J Stainless Threaded Shaft
S = Square Flange Pump Mount
D = D-Flange
M = JM Pump Shaft & Face
P = JP Pump Close Coupled
*Note: 100 = Rolled steel motor frame, plastic use, for indoor use (with Bluetooth)
101 = Rolled steel motor frame, aluminum covers, for indoor / outdoor / and
Plenum use (without Bluetoth), includes (M) Motor Only