ABB EC Titanium Series - Default Chapter; Table of Contents

iMN448
Table of Contents
Chapter 1
Introduction
1.1 Getting Assistance from ABB
.................................................. 1-1
1.2 Safety Notices. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1
1.2.1 Safety in Installation and Maintenance .................................... 1-1
1.2.2 General Safety ...................................................... 1-2
1.2.3 Safe Start-Up and Operation ........................................... 1-2
Chapter 2
General Information and Ratings
2.1 Type Designation Key
........................................................ 2-1
2.2 Nameplate and Type Designation Label .......................................... 2-2
2.2.1 Motor Nameplate .................................................... 2-2
2.2.2 Motor Setup Parameters .............................................. 2-2
2.2.3 Drive Nameplate and Type Designation Label .............................. 2-3
2.2.4 Motor and Drive Nameplate Locations .................................... 2-3
2.3 Model Numbers and Ratings .................................................. 2-4
2.3.2 Integrated Motor / Drive Model Numbers and Ratings ....................... 2-5
Chapter 3
Mechanical Information and Mounting
3.1 Receiving and Inspection
..................................................... 3-1
3.2 Mounting Location .......................................................... 3-1
3.3 Wiring Considerations. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1
3.4 Motor Mounting Lifting Positions ............................................... 3-1
3.3.1 Motor Lifting Postions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-2
3.5 Removing Drive Cover ....................................................... 3-2
Chapter 4
Electrical Installation and Planning
4.1 Motor Connections
.......................................................... 4-1
4.2 Protective Ground (PE) Connection ............................................. 4-2
4.2.1 Protective Earth Conductor ............................................ 4-2
4.2.2 Safety Ground ....................................................... 4-3
4.2.3 Motor Ground ....................................................... 4-3
4.2.4 Ground Fault Monitoring ............................................... 4-3
4.3 Incoming Power Connection .................................................. 4-3
4.3.1 Power Cable Selection ................................................ 4-3
4.3.2 Fuse / Circut Breaker Selection .......................................... 4-4
4.4 Optional Input Choke ........................................................ 4-5
4.5 EMC Compliant Installation ................................................... 4-5