ABB EC Titanium Series - Page 4

ii MN448
Chapter 5
Control Wiring & Keypad Interface
5.1 Control Terminal Connections
................................................. 5-1
5.2 Control Terminal Wiring ....................................................... 5-1
5.3 Remote Panel Interface ...................................................... 5-2
5.3.1 Cable Requirements .................................................... 5-2
5.3.2 Hardware Connection .................................................. 5-3
5.3.3 System Setup ......................................................... 5-3
5.3.4 To setup the communication address. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-4
5.3.5 Connection to a network of multiple drives .................................. 5-4
5.3.6 To setup the REMOTE PANEL device number ................................ 5-4
5.4 Control Signals ............................................................. 5-4
5.4.1 Analog Ouput ......................................................... 5-4
5.4.2 Relay Output .......................................................... 5-4
5.4.3 Analog Inputs ......................................................... 5-4
5.4.4 Digital Inputs .......................................................... 5-4
5.5 Motor Thermistor Connection .................................................. 5-5
5.6 Internal Thermal Overload Protection ............................................ 5-5
Chapter 6
Keypad Programming and Basic Operation
6.1 User Interface
.............................................................. 6-1
6.2 Real Time Operation ......................................................... 6-1
6.2.1 Pre-setting target speed in keypad mode ................................... 6-1
6.2.2 To vary the speed in real time keypad control mode ........................... 6-2
6.2.3 To reverse direction of rotation with Parameter 1103=2 ......................... 6-2
6.3 Keypad Operation and Remote Monitoring Displays ................................ 6-2
6.4 Remote Keypad Monitoring Screens ............................................. 6-3
Chapter 7
Quick Startup Guide
7.1 Quick Start Terminal Control
................................................... 7-1
7.2 Quick Start Motor Parameter Data .............................................. 7-1
7.3 Customize Your Application .................................................... 7-2
7.4 Quick Start Keypad Control .................................................... 7-3
Chapter 8
Parameter Navigation and Groups
8.1 Parameter Structure. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8-1
8.2 Parameter Navigation ........................................................ 8-1