ABB FENA-01 - Page 255

PROFINET IO – Start-up 255
22 MAP SELECTION Defines the preferred data type of mapped
parameters when mapping is done through
PROFIdrive parameters. Supported with
ACS880 and ACS580 drives.
1 = 16bit
ACS355:
FB PAR 22
ACSM1:
FBA PAR22
ACS850/ACQ810:
FBA par22
ACS880/ACS580:
Map selection
0 = 32bit 32 bits
1 = 16bit 16 bits
23
…
26
Reserved These parameters are not used by the adapter
module when the module is configured for
PROFINET IO.
N/A
27 FBA PAR
REFRESH
Validates any changed adapter module
configuration parameter settings. After
refreshing, the value reverts automatically to
0 = Done.
Note: This parameter cannot be changed
while the drive is running.
0 = Done
ACS355/ACSM1:
FBA PAR
REFRESH
ACS850/ACQ810:
FBA par refresh
ACS880/ACS580:
FBA A/B par refresh
0 = Done Refreshing done
1 = Refresh Refreshing
28 PAR TABLE VER Read-only. Displays the parameter table
revision of the fieldbus adapter module
mapping file stored in the memory of the drive.
In format xyz, where
x = major revision number
y = minor revision number
z = correction number
OR
in format axyz, where
a = major revision number
xy = minor revision numbers
z = correction number or letter.
N/A
ACS355:
FILE CPI FW REV
ACSM1:
PAR TABLE VER
ACS850/ACQ810:
Par table ver
ACS880/ACS580:
FBA A/B par table
ver
Parameter table revision
No. Name/Value Description Default