ABB FENA-11 - Tools; Target Audience; Purpose of the Manual

Introduction to the manual 23
 Tools
The FENA-11/-21 adapter module can be used in the Ethernet tool
network for ACS880 and ACS580 drives. The Ethernet tool
network enables commissioning and monitoring several single
drives, or inverter and supply units of a multidrive from a single
location by using the Drive composer pro PC tool.
Note: When the FENA-11/-21 adapter module is used only in the
Ethernet tool network, the recommended setting for parameters
50.21 FBA A timelevel sel and 50.51 FBA B timelevel sel is Slow.
For more information on the Ethernet tool network, see:
• Ethernet tool network for ACS880 drives application guide
(3AUA0000125635) [English])
• Drive composer user’s manual (3AUA0000094606 [English]).
Target audience
This manual is intended for people who plan the installation, install,
start up, use and service the adapter module. Before you do work
on the module, read this manual and the applicable drive/converter
/inverter manual that contains the hardware and safety instructions
for the product in question.
You are expected to know the fundamentals of electricity, wiring,
electrical components and electrical schematic symbols.
The manual is written for readers worldwide. Both SI and imperial
units are shown.
Purpose of the manual
The manual provides information on installing, commissioning and
using the FENA-01/-11/-21 Ethernet adapter module.