—
You may need
A mounting foundation/table with holes for securing
M10 screws and locating pin
A 0.4 mm (or smaller) slot screw driver (3
A wrench or a hex key fit for M10 screws (4
View product specification & data sheet for more
information. Access the documentations here:
https://to.abb/GZIOZHZX https://to.abb/eLKx7hK
You can buy the required accessories from ABB webshop:
https://webshop.robotics.abb.com/us/accessories.htm
4
3
Pin hole dimension (size: mm)
Robot base dimension (size: mm)
1
2
—
Preparation
03Step 1 | Preparation
To Next Page
Loading...
