ABB HT596388 - Figures

Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
Figures
© Copyright 2017 ABB. All rights reserved. HZTL4037_EN Revision E July 2017
Figures
Fig.1: Layout and function of the turbocharger...... 4
Fig.2: Position of the rating plate ............................... 5
Fig.3: Warning plates on the turbocharger .............. 6
Fig.4: Turbocharger transport..................................... 7
Fig.5: Removing the turbocharger............................. 9
Fig.6: Inserting O-rings into bracket ........................ 10
Fig.7: Inserting threaded rods into the bracket..... 11
Fig.8: Requirements for threaded rods ................... 11
Fig.9: Placing the turbocharger on the bracket ..... 12
Fig.10: Layout and overview of the speed measure-
ment system.................................................................. 20
Fig.11: Fitting the speed sensor ................................ 22
Fig.12: Noise insulation, bellows .............................. 24
Fig.13: Cleaning the filter silencer ............................. 31
Fig.14: Cleaning the compressor casing, diffuser
mechanically................................................................... 33
Fig.15: Cleaning the nozzle ring, turbine casing
mechanically.................................................................. 34
Fig.16: Soaking contamination of the turbine....... 36
Fig.17: Overview of assemblies................................. 50
Fig.18: Removing the gas outlet casing................... 51
Fig.19: Removing the air inlets.................................. 52
Fig.20: Removing the compressor casing (1/2) .... 53
Fig.21: Removing the compressor casing (2/2)..... 54
Fig.22: Do not loosen screw plugs ........................... 55
Fig.23: Removing the cartridge group (1)............... 56
Fig.24: Removing cartridge group 2 ......................... 57
Fig.25: Rotating the cartridge group and fitting the
service support.............................................................. 57
Fig.26: Removing the nozzle ring ............................. 58
Fig.27: Measuring clearance A and B ....................... 59
Fig.28: Measuring nozzle ring compression .......... 60
Fig.29: Fitting the diffuser.......................................... 61
Fig.30: Lifting the cartridge group and rotating it
by 90°.............................................................................. 62
Fig.31: Fitting the cartridge group............................ 63
Fig.32: Installing the nozzle ring ................................ 64
Fig.33: Fitting the turbine casing .............................. 65
Fig.34: Rotating the turbocharger ............................ 66
Fig.35: Measuring clearances N and R ...................... 67
Fig.36: Fitting the gas outlet casing......................... 68
Fig.37: Installing the air inlets .................................... 69
Fig.38: Overview of tightening torques ................... 70
Page 76 / 77Page 76 / 77