Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
9 Dismantling and fitting / 9.1 Introduction
© Copyright 2017 ABB. All rights reserved. HZTL4037_EN Revision E July 2017
9 Dismantling and fitting
9.1 Introduction
The condition for the work described below is that the turbocharger has been removed from
the engine (see chapter Removing and Installing →7).
WARNING
Danger of burns
Touching hot surfaces or contact with hot operating fluids can cause burns.
u Do not touch hot surfaces. Observe the warning plate on the turbochar-
ger.
u Wear heat-resistant safety gloves and protective clothing.
u Wait for the turbocharger to cool down before carrying out any work.
Wear safety gloves to protect against thermal hazards.
WARNING
Cutting injuries when working on the turbocharger
Some parts on the turbocharger may have sharp edges. There is a risk of a
cutting injury.
u Wear safety gloves against mechanical risks when conducting assembly
and disassembly work.
Wear safety gloves to protect against mechanical hazards.
CAUTION
Further operations
This Operation Manual may be used to carry out only those operations that
are described in it. Further operations that are executed in an incorrect way
can lead to serious damage to the machine.
u ABB Turbo Systems recommends having further operations carried out
only by trained personnel from an ABB Turbocharging Service Station.
Page 46 / 77
To Next Page
Loading...