3.6 Service Information System, M2000
3.6.1 Using the SIS system
General
This is a brief description of how to use the Service Information System, SIS for
M2000 robot systems. Details may be found in:
• Service Information System, SIS
• Defining the SIS input parameters
• Setting the SIS parameters
• Importing/exporting SIS data
• Reading the SIS output logs
The section is only valid for M2000 systems. For information regarding M2004
robot systems, see additional documentation, Operating manual - Service
Information System. Article number is specified in section References on page 10.
Basic procedure
ReferenceAction
These are described in Description of
Service Information System (SIS) on
page 104.
Determine which of the system functions
you require.
1
Recommendations on how to define these
are given in SIS system parameters on
page 107.
Define what values are adequate and suit-
able for your application in your production
environment.
2
How to do this is detailed in Setting the
SIS parameters on page 108.
Enter these parameters in the system.3
Run the robot in normal operation.4
The TPU displays for resetting any SIS
value are shown in Description of Service
Information System (SIS) on page 104.
Reset the counter if a repair is made, or if a
counter for any other reason is restarted.
5
How to access this is detailed in Reading
the SIS output logs on page 109.
When a time limit, set in the parameters, is
exceeded, a message may be read on the
Tech Pendant Unit (TPU).
6
These are described in Exporting the SIS
data on page 110.
If the log containing the message is to be
available from an external PC, or if the SIS
parameters are to be entered from an extern-
al PC, a set of software tools are available
to build such an application.
7
Product manual - IRB 2400 103
3HAC022031-001 Revision: P
© Copyright 2004-2018 ABB. All rights reserved.
3 Maintenance
3.6.1 Using the SIS system
To Next Page
Loading...
