NoteAction
Press the push buttons 1 to 6, one at a time, to
make sure that the buttons are moving freely and
do not stay in a locked position.
7
Detailed in the Calibration chapter
- section Updating revolution
counters on page 210.
If the battery has been disconnected the revolu-
tion counter must be updated.
8
DANGER
Make sure all safety requirements are met when
performing the first test run. These are further
detailed in the section First test run may cause
injury or damage on page 29.
9
Product manual - IRB 2400 163
3HAC022031-001 Revision: P
© Copyright 2004-2018 ABB. All rights reserved.
4 Repair
4.6.2 Replacement of brake release unit
Continued
To Next Page
Loading...
