Drivers
Safety position
24 3HEA 802352-001 Rev. A
3. Tap Setup.
4. Choose Set/Change robot safe position.
• Tap GO.
There is a position for each working
area.
If you are using a multi-robot system,
this procedure must be run for each
robot. Choose another robot by
choosing the tab for the robot for
which the safety position is to be set.
5. Tap OK.
The robotís safety position will now be
set. In multimove systems, program
execution must be stopped for all
tasks.
Action Info/Illustration
To Next Page
Loading...
