ABB PGC5007 - Flame out LED on; Flame will Not Ignite; No Analyzer Keypad Response

PGC5007
PGC5007 Operating Instructions 4 Maintenance information
20 OI/PGC5007-EN, Rev C
Defective
Keypad
Install new keypad
NO ANALYZER
KEYPAD
RESPONSE
Defective Cabling
Pressing keypad on analyzer front
panel produces no response on
CRT or other analyzer output.
Check cabling from keypad
to keypad assembly PCB
Insufficient
Burner Fuel
FLAME OUT LED
ON
Plugged Vent
Line
Flame Out LED indicates
flame is out
.
Defective port
on SBC
Insufficient Air
Insufficient
Burner Fuel
FLAME WILL NOT
IGNITE
Plugged Vent
Line
Flame Out LED on and continued
attempts to light the flame have failed.
Insufficient
Air
Defective
Ignitor
Incorrect Flame
Out Indication
Broken
Jet
Port
Failure
Splitter Flow
Not Set
Empty Permeation
Module
Detector
Electronics